Watch our ON-DEMAND WEBINAR: 

Making difficult PCB design decisions to
minimize electromagnetic interference
 
Sponsored by:     
 

As IOT products and devices get smaller and more powerful, it becomes challenging to balance the design goals, high speed, high density, low power, and reasonable cost.

Engineers must make delicate tradeoffs while keeping radiated emissions under control.

Tune in this webcast to learn:

  • How critical PCB design decisions affect the total radiated power;

  • How EMI (electromagnetic interference) simulations in the early design phase can prevent costly fixes later on;

  • How to use CST Microwave Studio to conduct EMI simulation.


Speakers:

Wayne Tanner   Wayne Tanner, COO - Adaptive Corporation

Michael Fogg   Michael Fogg, Senior Principal Engineer - Adaptive Corporation

Moderator: Kenneth Wong   Moderator: Kenneth Wong, Senior Editor - Digital Engineering

Watch On-Demand Webinar

You may unsubscribe from these communications at any time. For more information on how to unsubscribe, our privacy practices, and how we are committed to protecting and respecting your privacy, please review our Privacy Policy.

By clicking submit below, you consent to allow Adaptive to store and process the personal information submitted above to provide you the content requested.